Edu-Logger CO2 Logger Sensor

The Edu-Logger CO2 Logger Sensor sensor is based on an electromechanical reaction between CO² gas and the sensor. The Edu-Logger CO2 Logger Sensor results of the electromechanical reaction is measured in voltage.

The Edu-Logger CO2 Logger Sensor measurement units are ppm (parts of CO² per million of air).

Features of The Edu-Logger CO2 Logger Sensor

• A bottle adapted to the sensor is supplied.
• Converts the measured parameter into processed value (ºC, ºF, Lux, dB, mA, V, etc.)
• Sends the data in digital form to a viewer unit, any kind of computer or tablet.
• Saves up to 5 experiments in its flash memory.
• Calibration is done by pressing a push-button.
• Changing ranges and gains is done through software.
• Experiments run with or without a computer.
• Saved experiments in the Logger Sensor can be uploaded to a computer at any time.

Benefits of The Edu-Logger CO2 Logger Sensor

• The modular plug and play system allows the connection of sensors in a chain, in any order.
• Each sensor is in itself a full data acquisition system.
• Robust hardware and attractive design.
• Simple operation.
• No cable clutter, allowing simple construction of experiments.
• System allows wireless connection.

Specifications

• Experiment duration: 1 second to 31 days.
• Range and operation modes: 350 to 10,00 ppm.
• ADC resolution: 14 bit.
• Resolution: 1 ppm.
• Max sample rate (S/sec): 100.

Note: The sensor must be calibrated before every use according to the following simple procedure:

1. Connect the sensor to the PC through a USB module or to a battery module.
2. Wait for two minutes to the warm the sensor and press the pushbutton on the CO² logger sensor for 3 seconds.
3. A bottle adapted to the sensor is supplied.